Skip Navigation Website Accessibility

Embellish Bold Tearaway 20"x10yd EBT-20


If we do not have the full amount that you ordered of this item:    

Add to Cart

Embellish™ Bold Tearaway is for use to support large or dense embroidery on woven fabrics such as cotton, duck cloth, twill, denim or towels. One layer will support approximately 10,000 embroidery stitches. Use this non-fusible version as additional support for any fusible Embellish stabilizers by cutting a piece the same size as the embroidery hoop and floating it under the hoop.

Embellish™ Bold Tearaway features a multi-directional tear capability, easily pulling away clean from the embroidery design for a crisp look on the front and back. Also available in a fusible version.

To use Embellish™ Bold Tearaway:

  1. Hoop one layer of the stabilizer within the frame with the garment or fabric.  Be sure to use a piece at least one inch larger than the outer parameter of the embroidery frame.
  2. Embroider the design.  *Tip – If the design is denser than 10,000 stitches or if it is a poorly digitized design (too many stitches for design size), float an additional layer of Embellish™ Bold Tearaway between the hoop and the bed of the machine for each additional 10,000 stitches for added support!
  3. Remove the hoop from the machine and from the garment.
  4. Tear away as much of the Embellish™ Bold Tearaway stabilizer as possible.




7216 Hazelton-Etna Rd. SW
       Pataskala, OH  43062


We are located in central Ohio about 18 miles east of Columbus.

Hours: Mon-Wed 10am-5pm; Thur 10am-7pm; Fri-Sat 10am-5pm
Closed Sundays and most national holidays.